Product ID:INTERSHIELD PRORECO, PRA551
MSDS Date:03/11/1997
FSC:8010
NIIN:00N062018
MSDS Number: CHJCQ

COURTAULDS COATINGS INC

6001 ANTOINE DR
HOUSTON, TX 77091
US

Emergency Phone: 800-854-6813;800-424-9300(CHEMTREC)

Info Phone: 713-684-1563

Cage: 50411

INTERNATIONAL PAINT INC

HOUSTON, TX 77091 US

Telephone: 800-589-1267/800-854-6813

Cage: 26351

METHYL N-AMYL KETONE

CAS: 110-43-0

RTECS: MJ5075000

Fraction By Weight: 50-100%

OSHA PEL 100 PPM

ACGIH TLV: 50 PPM

B) REMOVE VOLATILES PRODUCED DURING CURE & DECOMP

RTECS: 9999999ZZ

COATED W/THIS PRODUCT.

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALATION: CAUSES NOSE AND THROAT
IRRITATION. EYE CONTACT: CAUSES EYE IRRITATION. SKIN CONTACT:
CAUSES SKIN IRRITATION. CAN BE ABSORBED THROUGH THE SKIN. MAY CAUSE
ORGAN DAMAGE. INGESTION: MAY BE FAT AL IF SWALLOWED AND MAY CAUSE
ORGAN DAMAGE. TOXICOLOGICAL INFO: THERE IS NO DATA AVAILABLE ON THE
(EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ: PRODUCT ITSELF. WARNING: THIS PRODUCT
CONTAINS A CHEMICAL KNOWN TO THE STATE OF CALIFORNIA TO CAUSE
CANCER.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:GENERAL: IN ALL CASES OF DOUBT OR WHEN SYMPS PERSIST, SEEK
MED ATTN. NEVER GIVE ANYTHING BY MOUTH TO AN UNCON PERSON. INHAL:
REMOVE TO FRESH AIR. IF DISCOMFORT IS PRESENT OR BRTHG IS ABSENT
GET MED AT TN IMMED. EYES: FLUSH IMMED W/PLENTY OFWATER FOR AT
LEAST 15 MIN UNTIL IRRIT SUBSIDES. IF IRRIT PERSISTS, GET MED ATTN.
SKIN: FLUSH W/LARGE AMTS OF WATER. USE SOAP IF AVAIL. REMOVE
SEVERELY (SUPDAT)

Flash Point:100F,38C
Lower Limits:1%
Extinguishing Media:FOAM, CARBON DIOXIDE, DRY CHEMICAL.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA AND FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:ISOLATE FROM HEAT, SPKS, ELEC EQUIP &
OPEN FLAME. CLOSED CNTNRS MAY EXPLODE WHEN EXPOSED TO EXTREME HEAT.
IN ABSENCE OF ELECTRICITY, WATER SPRAY (FOG (SUPDAT)

Spill Release Procedures:CONTAIN SPILLED LIQUID WITH SAND OR EARTH. DO
NOT USE COMBUSTIBLE MATERIALS SUCH AS SAWDUST. ABSORB SPILL WITH AN
INERT MATERIAL (EG DRY SAND OR EARTH), THEN PLACE IN A CHEMICAL
WASTE CONTAINER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:KEEP CNTNR CLSD. LOOSEN CLOSURE
CAUTIOUSLY BEFORE OPENING. STORE IN COOL, WELL VENTD PLACE AWAY
FROM INCOMPAT MATLS. (SEE STABILITY & REACTIVITY.)
Other Precautions:KEEP AWAY FROM HEAT, SPARKS & FLAMES. PROTECT MATL
FROM DIRECT SUNLIGHT. GROUND & BOND CONTAINERS WHEN TRANSFERRING
MATLS. EMPTY CONTAINERS MAY RETAIN HAZ PROPERTIES. FOLLOW ALL
MSDS/LABEL WARNINGS, E VEN AFTER THE CONTAINER IS EMPTIED.

Respiratory Protection:USE A RESPIRATOR APPROVED BY NIOSH AND IN
ACCORDANCE WITH 29 CFR 1910.134 TO REMOVE PARTICULATES (AND VAPORS
IF THERE IS OVEREXPOSURE TO VAPORS GENERATED DURING THE PROCESSING
OF THIS PRODUCT).
Ventilation:PROVIDE SUFFICIENT VENT IN VOL & PATTERN TO A) KEEP TLV OF
HAZ INGREDS BELOW LIMS SPECIFIED IN INGRED SECTION. (ING 2)
Protective Gloves:CHEMICAL RESISTANT GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPROVED EYE WASH & DELUGE SHOWER .
CLOTHING AS NEEDED; USE BODY PROTECTION TO AVOID CONTACT WITH
PRODUCT.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
EXPLO HAZ: NOZZ IS PREFERRED) MAY BE USED TO COOL CNTNRS. DECOMP &
COMBUST PRODS MAY BE TOXIC. FIRST AID PROC: CONTAM CLTHG (INCL
SHOES) & WASH BEFORE REUSE. IF IRRIT PERSISTS, GET MED ATTN.
INGEST: I F SWALLOWED, DO NOT INDUCE VOMIT. KEEP AT REST. GET
PROMPT MED ATTN.

Boiling Pt:B.P. Text:305F,152C
Vapor Density:HVR/AIR
Spec Gravity:1.227
Evaporation Rate & Reference:SLOWER/ETHER
Appearance and Odor:LIQUID.

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:MAY PRDCE HAZARDOUS FUMES WHEN HEATED
TO DECOMPOSITION AS IN WELDING. FUMES MAY PRDCE CARBON DIOXIDE &
CARBON MONOXIDE.

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH LOCAL, STATE AND
FEDERAL REGULATIONS. DO NOT INCINERATE UNOPENED CONTAINERS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.